Create analysis

Reading time: 0 minute(s) (0 words)

See how to create an analysis with SLI analyzer.

Tired of reading? Check out the video tutorial!

Configuration

When the data has already been imported, you can create an analysis. To do so, configure the following settings:

1. Open the analysis that is in the Import complete status.

2. Select the Error Budget Calculation Method.
   

   Nobl9 supports two methods of calculating error budgets: Occurrences and Time Slices. For more detailed information, refer to the SLO Calculations guide.

   • For the Time Slices method, enter the Time Slice Allowance and Target to define the reliability target for time slice and SLO.

   • For the Occurrences method, enter the Target to define the reliability target for SLO.

   note

   If you selected a threshold metric as a metric type when configuring the data import, you can also set target Values to compare the values gathered from the metric source. For example, if Values less than 200 is the objective for a good experience, values below 200 are considered good.

3. Click Analyze to see how your error budget performs with the selected values.

When the analysis is successfully performed, you can see its results and investigate the SLI chart, SLI values distribution chart, and Reliability Burn Down chart:

Image 1: Results of an SLI analysis

You can now adjust the data as much as you want until you understand your reliability.

The process of analysis can have three different statuses: Analyzing..., Analysis complete, and Analysis failed. For more detailed information on those statuses, refer to the SLI analyzer.

Check out the configuration video:

Video 1: Performing the analysis with SLI analyzer

• You can now play with the settings! Adjust the targets and view updated error budgets and error budget burn down.

Well done! Now, you can leverage the analysis results to adjust your SLO!